Maintenance - GYS START 200 Betriebsanleitung

Translation of the original instructions
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery against short-circuiting.
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse the
affected part of the body with plenty of water and seek immediate
medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the charging process, disconnect the battery charger from
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
Connection:
• This device must be connected to an earthed power supply.
• This machine is fuse-protected.
This hardware is compliant with the IEC 61000-3-12.
This equipment complies with the IEC 61000-3-11.

Maintenance:

• If the power supply cable is damaged, it must be replaced by the
manufacturer, its service agent or an equally qualified person.
START 200-300
EN
9