Force Reduction - struers TegraPol-21 Gebrauchsanweisung

Force Reduction

40
TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual
As soon as the TegraForce is connected, an additional topic is
available in the Configuration Menu.
Force Reduction is used to decrease the force gradually during the
last 30 seconds of the preparation time. The force is reduced in steps
of 5 N until the final force of 10 N is reached. Thus the surface finish
is finer and the preparation time in the following step can be reduced.
Force Reduction can be set to either On or Off and this setting is
valid for all the preparation steps carried out.


Press ENTER




Select Force Reduction and press ENTER
between ON and OFF.

to activate the CONFIGURATION Menu.

to toggle