Medtronic MiniLink REAL-Time Bedienungsanleitung Seite 12

MP6025647-21A3 / A
Once connected, the sensor requires a short warm-up period. The pump notifies you
when the warm-up period ends and the sensor is ready to use.
To connect the transmitter to the sensor:
1 If you are using Enlite Sensor (MMT-7008), apply the Enlite overtape to the sensor
and wait five minutes before connecting the transmitter. Consult the user guide for
your Enlite Serter for details on applying Enlite overtape. If you are using a different
sensor (MMT-7002/MMT-7003), wait 10 to15 minutes before connecting the
transmitter.
2 Touch the rounded end of the inserted sensor to prevent it from moving during
connection.
3 Hold the transmitter as shown. Line up the two notches on the
transmitter with the side arms of the sensor. The flat side of the
transmitter should face the skin.
4 Slide the transmitter onto the sensor until the sensor's flexible
arms snap into the notches on the transmitter. If the transmitter
is properly connected, and if the sensor has had enough time to
become hydrated, the green light on the transmitter will flash
within 10 seconds.
5 If the transmitter light does not flash, disconnect it from the sensor, wait for several
seconds and then reconnect. If the transmitter light still does not flash, charge the
transmitter.
6 After the transmitter light flashes green, use your pump or monitor to communicate
with the sensor. For more instructions, see the user guide for your pump or monitor.
7 After the transmitter successfully sends sensor data to the pump or monitor, attach
the adhesive tab from the Enlite sensor (MMT-7008) to the transmitter. For other
sensors (MMT-7002 or MMT-7003), continue to the next step.
8 [Optional]: Apply occlusive dressing over the transmitter and the sensor.
Disconnecting the transmitter from the sensor
1 Carefully remove any occlusive dressing from the transmitter
and sensor.
2 For the Enlite sensor, remove the adhesive tab from the top of
the transmitter.
3 Hold the transmitter as shown, and pinch the flexible side arms
of the sensor between your thumb and forefinger.
4 Gently pull the transmitter away from the sensor.
-6-