Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MP6025647-21A3 / A
Note: A new AAA or LR-03 battery contains enough power to recharge the transmitter
more than 40 times. If the battery is installed incorrectly or is low, the charger will
not work. Repeat the battery installation steps using a new battery.
Installing a battery in the charger
1
Push the battery cover in and slide it off (as shown).
2
Insert a new AAA or LR-03 battery. Make sure that the + and - symbols on the battery
align with these same symbols shown on the charger.
3
Slide the cover back on the charger until it clicks into place (as shown).
Charging the transmitter
Before using the transmitter for the first time, you must fully charge the transmitter
battery. This may take up to eight hours. It is recommended to recharge the transmitter
after each sensor use. If you choose to recharge the MiniLink after a 6-day sensor use,
-4-
Werbung
Inhaltsverzeichnis
Fehlerbehebung
