Performance Data; Construction And Function; Summary; Functional Description - oventrop Unibox T SH Einbau- Und Betriebsanleitung

3.2. Performance data

Max. operating pressure:
Max. differential pressure:
Max. operating temperature: 100 °C
Temperature range:
(room temperature)

4. Construction and function

4.1. Summary

1. Wall box unit
2. Elbow
3. Valve body with presettable valve insert
and connections for compression fittings G
¾ cone "Euro"
4. Venting valve
5. Angle pattern adapter
6. Frame support
7. Counternut for frame support
8. Room thermostat
9. Frame
10. Fixing screws for frame
11. Cover plate
8
9
10
10
11
Illustr. 4.1 Summary "Unibox T SH"
10
10 bar
1 bar
7 - 28 °C
4 1
7
5
2
6
3
6 7
Installation and operating instructions

4.2. Functional description

The "Unibox T SH" is an installation set wor-
king without auxiliary energy for individual
room temperature control in surface heating
systems with suitable flow temperatures.

5. Installation and assembly

5.1. Extent of supply

Upon receipt, check delivery for any damages
caused during transit. Carry out visual check
of the protection caps for damages. Check in-
side of valve for impurities.
Any damages must be reported immediately
upon receipt.
Only remove protection caps and other trans-
port protections immediately before installa-
tion.

5.2. Installation of the "Unibox T SH"

The lower edge of the "Unibox T SH" should
be at least 20 cm above the finished floor, the
front edge should be on a level with the finis-
hed wall. The thickness of plaster and tiles has
to be taken into consideration. A comfortable
operation is given if it is installed at the height
of light switches.
2
Illustr. 5.1 Illustrated section "Unibox T SH" in
the wall
"Unibox T SH"
Block or stud wall
Wall box unit
Presettable valve with
thermostat "Uni SH"
Connecting pipe
Plaster
Edge isolating strip
Protection pipe
Screed