Use On Clothing; Use On Curtains And Upholstery; Lint Brush; Ironing Function - Silvercrest SDRB 1000 B1 Bedienungsanleitung

Use on clothing

♦ Hang the creased piece of clothing onto a coat
hanger .
♦ Gently stretch the item with one hand and hold
it, then apply steam from top to bottom . Com-
bine steam with the clothes brush r for gentle
removal of all creases .
♦ Gently apply pressure with the clothes brush r
and move the appliance over the piece of cloth-
ing from top to bottom . You can press the steam
burst button 8 at brief intervals .
NOTE
► Only repeat pressing the steam burst button 8
until the heat-up indicator lamp 5 lights up or
water drips from the ironing sole 0 . Wait until
the heat-up indicator lamp 5 goes out before
initiating another burst of steam .
♦ If the heat-up indicator lamp 5 lights up during
operation, do not press the steam blast button
8 again . Wait a few seconds until the heat-up
indicator lamp 5 goes out before pressing the
steam blast button 8 again .
NOTE
► If you press the steam burst button 8 while the
heat-up indicator lamp 5 is illuminated, the
appliance will produce condensation instead
of steam, and water will drip from the ironing
sole 0 .
♦ Allow treated clothes to cool down on a coat
hanger before wearing them .

Use on curtains and upholstery

♦ You can remove creases and wrinkles from
draperies by hanging them on a rail .
♦ Simply adhere to the instructions under "Use on
clothing" .
♦ Always carry out a test treatment on an invisible
patch of the item .
♦ If you are using the appliance horizontally, turn
it vertical every now and then to produce the
greatest possible amount of steam .
■ 20 │ GB │ IE

Lint brush

♦ To remove lint, string and hair, slowly guide the
red lint brush e over your clothes from left to
right .
♦ Moving the lint brush e over scrap fabric or
similar materials in the opposite direction (i .e .,
from right to left) will clean the brush .

Ironing function

♦ Remove the brush extension w from the ap-
pliance (see "Attaching/removing the brush
extension") .
♦ The appliance must be connected to correctly
installed and earthed mains power sockets only .
♦ Set the temperature control 3 in accordance
with the international care symbols (laundry
label) or the type of fabric . The heat-up indicator
lamp 5 lights up . As soon as the selected tem-
perature has been reached, the heat-up indicator
lamp 5 goes out .
Laundry Type of
label
Synthetic fibre
e .g . viscose,
polyester
Silk, wool
NOTE
► If in doubt, start with a low temperature and
gradually increase it . For sensitive fabric, we
recommend that you iron an invisible patch
(inside of the seam) first to ensure that the
ironing process does not cause damage .
Temperature
fabric control 3
•
(low
temperature)
••
(medium
temperature)
•••
cotton,
(high
linen
Temperature)
SDRB 1000 B1