Identification; Installation; Mechanical Mounting - Siko IG06 Originalmontageanleitung

IG06, IG07

Identification

Rotating parts
WARNING
Bruising, rubbing, abrasing, seizing of extremities or clothes by touching
during operation any rotating parts as for example shaft.
` Install protective facilities to prevent people from getting access.
3 Identification
Please check the particular type of unit and type number from the identifi-
cation plate. Type number and the corresponding version are indicated in
the delivery documentation.
e. g.

4 Installation

4.1 Mechanical mounting

Destruction of main bearings
CAUTION
Improper installation (e. g. tension on the shaft) causes additional heat
development and destruction of the incremental encoder in the long term.
` Ensure a low shaft and angle offset between shaft and accommodation
Incremental encoder failure
CAUTION
` When mounting pay attention to the IP type of protection (see chap-
` Do not open the incremental encoder yourself.
` Avoid impact on the device.
` Do not modify the device in any way.
Loss of type of protection
NOTICE
Sealing rings in the ball bearing are wearing parts! Therefore, the type of
protection depends on the service life and condition of the sealing rings.
Mounting the encoder
• Fasten the encoder by means of screws or torque pin and clamping of
IG06, IG07 · Date 08.03.2019 · Art. No. 79650 · Mod. status 33/19
-
IG06 0023
variant number
type of unit
bore by applying appropriate manufacturing methods.
ter 8).
the shaft. Take care to mount the incremental encoder free from dis-
tortion.
English 23