Connectors - Axis Q3505-SVE Wartung Und Service

AXIS Q3505-SVE Mk II Fixed Dome Network Camera
Technical specifications

Connectors

SD card slot
NOTICE NO NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the Axis product's webpages before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com
Audio connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A stereo connector must be used for audio out.
3.5 mm audio connectors
(stereo)
Audio Input
Audio Output
The internal microphone is used by default; the external microphone is used when connected. It is possible to disable the internal
microphone by connecting a plug to the microphone input.
I/O connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – For connecting devices that can toggle between an open and closed circuit, for example: PIRs, door/window
contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes active (shown
under System Options > Ports & Devices).
4-pin terminal block
1 Tip
Balanced: 'Hot' signal Microphone/Line in
Unbalanced: Microphone/Line in
Line out, mono (stereo connector
compatible)
2 Ring
Balanced: 'Cold' signal Microphone/Line
in
Unbalanced: Unused
Line out, mono (stereo connector
compatible)
72
3 Sleeve
Ground
Ground