Connectors And Buttons - Axis Q1614-E Montageanleitung

LED Indicators
Note
The housing LED referred to in the table below is located in the housing.
Housing LED
(fan and heater)
Green
Flashing green

Connectors and Buttons

For specifications and operating conditions, see page 17.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2.
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC reference
point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
buttons on the Live View page or by an Action Rule. The output will show as active
(shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open
and closed circuit, for example: PIRs, door/window contacts, glass break detectors,
AXIS Q1614-E Network Camera
Indication
Normal operation.
Single flash: Heater error
Double flash: Fan error
Triple flash: General error
Alarm events will be triggered through the camera's input port.
Contact your Axis reseller for information about spare parts and
troubleshooting.
15