Reset To Factory Default Settings - Axis Q3505-SVE Wartung Und Service

AXIS Q3505-SVE Mk II Fixed Dome Network Camera
System Options
To open Plain Config, go to System Options > Advanced > Plain Config. Axis Support does not provide assistance with this feature.

Reset to factory default settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset all settings, including the IP
address, to the factory default values.
Note
The installation and management software tools are available from the support pages on www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See Hardware overview on page 7 .
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes amber.
4. Release the control button. The process is complete when the status LED indicator turns green. The product has been reset
to the factory default settings. If no DHCP server is available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the password, and access the video stream.
It is also possible to reset parameters to factory default via the web interface. Go to Setup > System Options > Maintenance and
click Default.
66