Access The Product; Reset To Factory Default Settings; Further Information; Warranty Information - Axis Q60 Serie Installationsanleitung

Access the Product

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
To reset the product to the factory default settings:
1. Press and hold the control button and the power button for about 15 seconds until the
status LED indicator flashes amber. See Hardware Overview, on page 10.
2. Release the control button but continue to hold down the power button until the status
LED indicator turns green.
3. Release the power button and assemble the product.
4. The process is now complete. The product has been reset to the factory default settings.
If no DHCP server is available on the network, the default IP address is 192.168.0.90
5. Use the tools provided on the Installation and Management Software CD to assign an IP
address, set the password and access the video stream. This information is also available
from the support pages on www.axis.com/techsup/
It is also possible to reset parameters to factory default via the web interface. Go to Setup
> System Options > Maintenance.

Further Information

The User Manual is available at www.axis.com
Visit www.axis.com/techsup/ to check if there is updated firmware available for your network
product. To see the currently installed firmware version, go to Setup > About.
Visit Axis learning center www.axis.com/academy/ for useful trainings, webinars, tutorials and
guides.

Warranty Information

For information about Axis' product warranty and thereto related information, see
www.axis.com/warranty/
26
AXIS Q60 Series