AXTON A590DSP Einbau & Bedienungsanleitung Seite 7

Gain Phase
In this menu you can make the following
settings for each individual channel: sound
level, mute and phase. The sound level set-
tings are made in the field above and under
the respective speaker icons.
In the lower area of the menu in the top line
are the icons for setting the phase. From
left to right: Front left, Front right, Rear left,
Rear right, Subwoofer.
In the bottom line are the icons for setting
the mute switch. From left to right: Front
left, Front right, Rear left, Rear right, Sub-
woofer.
When you have done the settings, go back
to the main menu, and touch the „Save
to Amplifier" button to transfer the
settings to the amplifier. During the sav-
ing process do not switch off the amplifier
as this may lead to malfunction and/or
damage. You can also save the settings on
your smartphone. To do this, press „Save
on Phone" , and enter the desired
filename.
Noise Gate
In the upper right corner of the GAIN menu
you can find the Noise Gate function. It's a
dedicated to reduce the back ground noise
of the head unit. If back ground noise of
the head unit is audible, increase the Noise
Gate level by sliding to the left until you
cannot listen the noise anymore.
Noise Gate
function top right
Gain Phase
Gain Phase
– 12 –
Crossover
In this menu you can assign a frequency
band to the connected speakers that cor-
responds to their recommended operat-
ing range. You can chose to adjust each
channel separately, combine front and rear
speakers and also all speakers together.
In the left half of the diagram you can set
the break frequency of the high pass filter
as well as its slope. In the right half are the
break frequency and slope of the low pass
filter. The blue line shows the set slope of
the filter. „Bypass" means that the signal is
unfiltered and contains all frequencies.
The filter settings also apply to the corre-
sponding preamp outputs.
When you have done all settings, go back
to the main menu, and touch the „Save
to Amplifier" button to transfer the
settings to the amplifier. During the saving
process do not switch off the amplifier as
this may lead to malfunction and/or dam-
age. You can also save the settings on your
smartphone. To do this, press the „Save on
Phone" button , and enter the desired
filename.
Crossover
– 13 –