Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL SPECIFICATIONS A590DSP / A540DSP
A590DSP
Music Power Output:
76 W x 4 @ 4/2 ohms
RMS Power Output:
50 W x 4 @ 4/2 ohms
Frequency response:
20Hz ~ 20 kHz
Audio sampling frequency:
192 kHz
Distortion:
1 KHz <0.001%
Supply voltage range:
9V - 15V
Signal to noise ratio :
> 120 dB
Dynamic range :
> 96 dB
Standby current:
0 mA
Maximum operating current:
20 A
Dimensions (LxWxH):
185(218*) x 114 x 40 mm
* Including BT antenna
MAIN FEATURES
4-channel Smart Digital Amplifi er with iOS or Android App controlled audio DSP
n
functions
DSP-controlled 5-channel Preout (6 Volt) including REM out to control additional
n
amplifi ers
Bluetooth Audio Streaming with automatic source switching
n
Plug'N'Play quick installation system via optional vehicle brand and model specifi c ISO
n
wire harness
Auto-Turn-On function
n
FUNCTIONALITY & ADJUSTABILITY
Bluetooth connection and control of DSP settings via iOS or Android Smartphone App
n
Freely confi gurable active crossover: High-/Low-/Band-/Bypass with 6/12/18/24dB/
n
Oct. slope for Front, Rear and Subwoofer channel
Time Alignment in cm (0 – 420 cm) for front, rear and subwoofer channel
n
5 channel control: Gain, Phase switch and Mute function for each speaker
n
Freely confi gurable 10 or 31-band parametric Equalizer for every single front and rear
n
speaker
Freely confi gurable 5-band parametric Equalizer for subwoofer channel
n
Can save 5 memories in the amp and unlimited sound settings on the smartphone
n
Dynamic Bass setting for powerful performance without subwoofer
n
Noise Gate function to reduce car stereo background noise
n
A540DSP
54 W x 4 @ 4 ohms
32 W x 4 @ 4 ohms
20Hz ~ 20 kHz
192 kHz
1 KHz <0.001%
9V - 15V
> 120 dB
> 96 dB
0 mA
15 A
145(177*) x 114 x 40 mm
– 4 –
INSTALLATION DIAGRAM
MOUNTING INSTRUCTIONS
1. Before you start with the installation, make sure you know the security code of your
headunit (if applicable).
2. Remove the headunit from the dashboard and disconnect the main wire.
3. Find a place for the A590DSP or A540DSP and connect the provided (or optionally
available car-specifi c) wire to the amp.
4. A590DSP only: For more power output please follow these steps: Run a 10 mm
power wire from the (+) pole of the battery to the (BATT) terminal of the amplifi er.
Use a fuse with the related value of the cross section of the power wire. The distance
between the B+ pole and the fuse holder must be 30 cm or less. Run the minus cable
with the same cross section from the (GND) terminal of the amp to the vehicle chassis
ground. Make sure that the contact surface is clean in order to get best conductance.
5. Connect the wire to the headunit.
6. Install the headunit back in the dashboard.
ORIGINAL CAR SOCKETS
HEAD UNIT
– 5 –
2
Werbung
