Hauff-Technik MSH Basic-FUBO-E-SR4 Montageanweisung Seite 31

MSH Basic-FUBO-E-SR4 / MSH Basic-MBK-R4
Then release wing screws, hold onto ground spike and
4
remove MSH Basic-FUBO-E-SR4.
Insert the included impact screw into the ground spike
and fasten with the wing screw (see Fig.: 6).
Strike the ground spike into the ground by approx. 300 mm
5
or until sufficiently fastened.
Remove impact screw again (see Fig.: 7).
Place MSH Basic-FUBO-E-SR4 (basic unit) upside down
6
on the ground.
Spread sufficient GMT lubricant on the KES hose systems
on the locking sleeve inside as well as the sealing rings at
the end of the pipes (see Fig.: 8).
Insert KES hose systems with the locking sleeve side onto
7
the pipe ends until they audibly engage (see Fig.: 9).
Art. Nr.: 5090032065 Rev.: 03/2018-09-25
EN
Fig.: 6
Fig.: 7
Fig.: 8
Fig.: 9
31