Cola TOPFIRE 70 Installations-, Bedienungs- Und Wartungsanleitung Seite 57

From the main menu, press buttons P7
and P3 in rapid succession, to activate
or deactivate the keylock function.
The two messages shown opposite
appear on the display.
Press button P7 to access the list of submenus. They allow the electronic controller settings to be changed. The
various submenus can be scrolled by pressing buttons P1 and P2, and can be accessed by pressing button P7 and
exited by pressing P3.
MENU 02 – Set clock
Before operating the insert, the current time and date must be set in order to have a reference for possible chrono
programming.
The electronic control has a 3-volt lithium battery model CR2032 that gives the internal clock an operation
autonomy; battery replacement is necessary if the clock does not keep the time with the insert not powered, or a
series of zeros appears at restart: call an authorized service center.
To set the clock, access the menu by pressing P7 and set the day with buttons P1 and P2. Press P7 again to set
the hours, minutes, day, month and year.
MENU 03 – Set chrono
Allows all time programming functions to be enabled/disabled. To enable the chrono, access the first submenu
ENABLE CHRONO and set it to ON with buttons P1 or P2. The manual commands from the emergency panel or
remote control have priority over programming.
The insert is equipped with three different types of programming: daily, weekly and weekend.
Chrono enabling is signaled by the LEDs shown in the picture below. Daily, weekly and weekend programming is
active only if the general chrono is enabled.
Enable chrono
Access the second submenu DAY PROGRAM to enable or disable daily programming with buttons P1 and P2.
Then press button P7 and then buttons P1 and P2 to set up to two operation phases delimited by the set times.
Access the second submenu WEEK PROGRAM to enable, disable and set the weekly programming functions.
Follow the same procedures of the previous paragraph. Up to four operation phases delimited by the set times and
days can be set.
Carry out programming making sure not to overlap the hours of activation and/or deactivation on the same
day in different programs.
Access the third submenu WEEKEND PROGRAM to enable, disable and set the weekly programming functions for
the weekend. Follow the same procedures of the previous paragraph. Up to two operation phases delimited by the
times can be set.
To avoid unwanted startup and shutdown operations, activate only one program at a time.
Enable weekend programming
Enable weekly programming
Enable daily programming
57 TOPFIRE 70 – TOPFIRE 80