Settings; Special Operation; Clearing Remote Controls - SOMFY FREEROLL RTS Montageanleitung

SETTINGS

RESET
DIP 2

SPECIAL OPERATION

Cf. page 10 of the User Manual

CLEARING REMOTE CONTROLS

Press the « RTS Prog » button inside the FREEROLL until the light blinks (7 s).
This clears all of the remote controls memorised.
Warning! To validate and take into account the new settings
for the Switch 1 of DIP1 and all the switches of DIP 2, press
the RESET button on the top of the electronic board.
Dip Switch Settings
DIP 1
Switch 1 ON
DIP 1
Switch 1 OFF
Switch 2 ON
Switch 2 OFF
Switch 3 ON
Switch 3 OFF
Switch 4 ON
Switch 4 OFF
DIP 2
Switch 1 ON
Switch 1 OFF
Switch 2 ON
Switch 2 OFF
Switch 3 ON
Switch 3 OFF
Switch 4 ON
Switch 4 OFF
Standard operating mode
PEC self-check software on (always
used if cells connected)
PEC self-check software off
Dead Man open
Push to Run open
Dead Man Close
Push to Run Close
Programming Mode
Normal Running Mode
Anti-lift function disabled
Normal Running Mode
Generator Mode Enabled (only with
optional generator)
Normal Running Mode
Do not use
Normal Running Mode
Do not use
Normal Running Mode
37