Commission The Safety Edge; Programming - SOMFY FREEROLL RTS Montageanleitung

6. Commission the safety edge

« Solid
Green »
AT THIS STAGE OF THE INSTALLATION PROCESS, THE FREEROLL RTS CONTROL SYSTEM
IS NOW READY-TO-USE.

PROGRAMMING

Warning! The remote controls provided with the kit are factory pre-programmed on the left first
channel button.
They can be directly used to control the rolling garage door.
Add new remote controls
Up to 36 control channels can be stored.
Running this procedure for a previously stored channel will clear it.
Add a Keytis or similar remote controls
... 2 min
Warning! It is crucial to respect the following procedure to
secure the functioning of the door.
Open the door fully pressing the
Close the door fully pressing the
Warning! If t he cover buttons do not work properly, the
connector lead may be plugged in the wrong way
Warning! At this stage do not press the safety edge
Re-open the door fully pressing the
Re-close the door pressing the
during the closing that the safety edge is working by pressing it.
If the safety edge is active, the door will stop and reverse partially.
If not, stop the door (STOP button) manually and please refer to the
troubleshooting guide page 38.
button on the cover.
button on the cover.
button on the cover.
button on the cover and test
Push the « RTS Prog » button
inside the FREEROLL for 3
sec until the RTS red LED
lights.
Within 2 minutes, push the
desired channel button of the
RTS remote control.
The RTS red LED will blink for
5 sec and then switch off.
33