Herunterladen Inhalt Inhalt Diese Seite drucken

General Presentation; Safety Instructions; Caution; Product Description - SOMFY FREEROLL RTS Montageanleitung

Empfänger für die steuerung und sicherheit von garagenrolltoren
Vorschau ausblenden Andere Handbücher für FREEROLL RTS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GENERAL PRESENTATION

When installed in line with these instruction, the product will be compliant with standards EN 13241-1,
EN 12453.
The instructions referred to in the installation manual and instructions for use of this product are
designed to prevent damage to property and personal injury along with compliance with the above
standards. Failure to comply with these instructions absolves Somfy from any liability resulting from
damage that may be caused.
FREEROLL is a product that must be installed inside the garage with an integrated back-up control
system (refer to the instructions of RDO CSI motors).
Somfy hereby declares that the device is compliant with the essential demands and other relevant
requirements of directive 1999/5/CE.
A declaration of compliance is available from the web site at www.somfy.com/ce (FREEROLL RTS).
This product is suitable for use in the European Union and in Switzerland.

SAFETY INSTRUCTIONS

1. Caution

These are important safety instructions. Always follow the instructions, incorrect installation may lead
to serious injury.
2. Safety instructions
Refer to the rolling door and RDO CSI motor safety instructions before installing the control receiver
unit.
To prevent undesired operation by children, locate all control systems at least 1.5 meter above floor
level, making sure that they are visible from the entrance to the garage but safe from moving parts.

PRODUCT DESCRIPTION

1. Product components (see page 2)
Key Number Description
1
1
FREEROLL control unit factory pre-cabled (European plug)
2
-
Control unit cover
3
1
Built-in light cover
4
1
Cable clamp
5
1
Cover LED (with its connector)
6
1
Front cover buttons connector lead
7
1
Safety Edge Transmitter factory pre-programmed
8
-
Safety Edge Transmitter back
9
-
Safety Edge Transmitter cover (with electronic board)
10
2
Magnet
11
2
Keytis 2 RTS remote control factory pre-programmed (on channel 1: left button)
12
2
Aerials
13
1
Fixation bag
14
1
230 V E14 25W max Socket Light Bulb
24

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis