Quick Installation Guide; Set Motor End-Limits; Position The Top And Bottom Magnets On The Door Guide; Door Position - SOMFY FREEROLL RTS Montageanleitung

QUICK INSTALLATION GUIDE

Warning ! From Step 1 to Step 3, you must use a test lead to operate the rolling garage door.
Do not connect the FREEROLL control unit until the end-limits have been set.

1. Set Motor end-limits

Set the UP and DOWN end-limits of the RDO CSI motor with a test lead (not-provided).
Refer to the motor instruction guide.

2. Position the TOP and BOTTOM Magnets on the door guide

Warning ! Position the magnets, the Safety Edge Transmitter and the FREEROLL control unit
on the same side of the door
10 mm maxi. 10 mm maxi.

3. Door position

ground ground ground
Back of the Back of the
Safety Edge Safety Edge
Transmitter. Transmitter.
50 mm mini. 50 mm mini.
60 mm maxi. 60 mm maxi.
TOP Magnet TOP Magnet
BOTTOM Magnet BOTTOM Magnet
TOP TOP
Magnet Magnet
Back of the Back of the
Safety Edge Transmitter Safety Edge Transmitter
BOTTOM BOTTOM
Magnet Magnet
Place the back of the Safety Edge Transmitter against
the bottom slat of the door respecting the space of 10
mm maximum with the edge of the guide.
Warning! The Magnets are used to activate and
deactivate the safety edge.
They must be positioned as indicated and never
removed (autonomy and safety managements).
Fit the TOP Magnet: the door must be in the OPEN end-
limit position. Remove the backing strip and screw the
magnet on the guide respecting the distance (height) of
50 mm minimum and aligning with the edge of the guide.
Fit the BOTTOM Magnet: the door must be in the
CLOSED end-limit position. Remove the backing strip
and screw the magnet on the guide respecting the
alignment with the Safety Edge Transmitter.
Move the door to a mid position.
26