Using The Lamp With A Somfy Io Local Control Point; Additional Settings; Adding / Deleting Somfy Io Local Control Points; Creating Multiple Or Group Controls - SOMFY Lighting Receiver io Installationsanleitung

Lighting receiver io
6. USING THE LAMP WITH A SOMFY IO LOCAL CONTROL
POINT
To switch the light on:
- Press the up button.
To switch the light off:
- Press the down button.
The "my" button has no effect.

7. ADDITIONAL SETTINGS

7.1. Adding / Deleting Somfy io local control points

7.1.1 Somfy io local control point
a maximum of 9 control points can be programmed
into an io Lighting Receiver.
3) Press the PROG button on the programmed control
point (a) until the light comes on and then goes out: the
io Lighting Receiver will be in programming mode for
10 mins.
4) Briefly press the PROG button on the Somfy io local
control point (b) to be added / deleted: the light will
come on and then go out; the io control point has been
added / deleted.

7.2. Creating multiple or group controls

7.2.1 Group control
Group control: a Somfy io local control point controls several io Lighting Receivers.
1) Cut the power supplies corresponding to the io Lighting
Receivers (e, f and g) to be controlled with the single
control point.
2) Activate the power to the first io Lighting Receiver (e) to
be linked to the control point.
3) Press the Up/Down buttons simultaneously on the Somfy
io local control point: the light will come on and then go
out.
4) Press the PROG button on the Somfy io local control
point: the light will come on and then go out again to
indicate that the Somfy io local control point has been
programmed into the io Lighting Receiver
5) Activate the power to another io Lighting Receiver to be
linked, and repeat steps 3) and 4)
- Repeat the procedure for each of the other io Lighting
Receivers to be controlled with this Somfy io local control
point.
28
1
PROG. A
+
1
PROG. A
1
OFF
e
2
ON
e
4
e
Copyright © 2009 Somfy SAS. All rights reserved.
Installation guide
+
2
PROG. B
10 min.
+
2
PROG. B
10 min.
f g
3
e
e