Position The Top And Bottom Magnets On The Door Guide - SOMFY FREEROLL RTS Montageanleitung

2. Position the TOP and BOTTOM Magnets on the door guide

Warning! Position the Magnets, the Safety Edge Transmitter and the FREEROLL control unit on
the same side of the door
Back of the Back of the
safety edge safety edge
transmitter. transmitter.
10 mm maxi. 10 mm maxi.
Remove the Safety Edge Transmitter from the box.
Place the back of the Safety Edge Transmitter against the
bottom slat of the door . If needed, adjust the back of the
Safety Edge Transmitter respecting the given dimensions
(photo).
Feed the cable from the safety edge through the hole and
secure the back of the Transmitter to the door with the screws
provided. The flat edge of t he Transmitter must be
mounted within 10 mm maximum of the guide where the
magnets are to be fixed.
Warning! The Magnets are used to activate and
deactivate the safety edge.
They must be positioned as mentioned below and never
removed (autonomy and safety managements).
To position the TOP Magnet, position the rolling garage
door at its top end-limit. Measure down 50 mm minimum
from the bottom of the back of the Safety Edge Transmitter.
The TOP Magnet housing should be placed flush with the
edge of the guide (See photo).
50 mm mini. 50 mm mini.
60 mm maxi. 60 mm maxi.
Clean the area first with the wipe supplied and allow to dry.
TOP Magnet TOP Magnet Fix the TOP Magnet to the guide using the adhesive pad
provided and secure it with the 2 fixing screws provided.
To position the BOTTOM Magnet, close the door to the
down end-limit. Align both Transmitter and BOTTOM
Magnet.
The BOTTOM Magnet housing should be placed flush with
the edge of the guide.
BOTTOM Magnet BOTTOM Magnet
Clean the area first with the wipe supplied and allow to dry.
Fix the BOTTOM Magnet to the guide using the adhesive
pad provided and secure it with the 2 fixing screws provided.
29