Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL CC-TJ 2000 Originalbetriebsanleitung

side of the hydraulic pump. This valve is set at
the factory so that the maximum load cannot be
exceeded.
Do not adjust this valve or you will forfeit
your rights under the warranty if the jack
suff ers any damage.
Once the jacking arm reaches its highest position,
the safety valve and an overfl ow device will
prevent additional pressure being exerted on the
hydraulic system even if you continue to pump
with the jacking bar.
The required forces exceed 400 N and must be
reduced by involving more people.
7. Cleaning, maintenance and
ordering of spare parts
Lifting equipment must be serviced and
repaired in accordance with the manufacturer's
instructions. The servicing and repairs must be
performed by experts.
Only original spare parts may be used.
7.1 Maintance
All moving joints should be oiled and the roller
bearings of the steering wheels greased every
three to six months, depending on how often the
trolley jack is used. Every hydraulic system is
sealed with O-rings or cup packings which result
in wear depending on how often the trolley jack
is used. Repair sets are available from Customer
Service on request. To prevent damage to the
seals, use only acid-free hydraulic fl uid to top up
the system.
Catch old and escaping fl uid in a special
container and deliver to your old oil disposal
center!
You should always move the hydraulic system
(piston) to idle position (piston inserted) once the
trolley jack is no longer needed. This will protect
the precision-machined surfaces of the piston
and the piston rod from corrosion.
Your trolley jack will give you good service if you
use only high-grade hydraulic fl uid. Never mix
diff erent types of fl uid! Never use brake fl uid,
alcohol, glycerin, dirty fl uid, etc.
Anl_CC_TJ_2000_SPK9.indb 11 Anl_CC_TJ_2000_SPK9.indb 11
GB
7.2 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 11 -
05.09.2018 08:07:02 05.09.2018 08:07:02