Safety Regulations; Layout And Items Supplied; Proper Use - EINHELL CC-TJ 2000 Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

•
Before you raise the load, check that the
lowering screw is tightly shut.
•
Always place the hydraulic trolley jack on firm
and level ground when using it to raise a load.
•
Never work underneath a raised load which
is supported only by the hydraulic trolley jack.
Working on and under raised vehicles is only
permitted when the vehicle in question is
secured and supported against tipping and
slipping.
•
The trolley jack is designed only for raising
loads. After a load is raised it must be
supported immediately by at least one jack
stand. Vehicles must be sufficiently secured
against rolling before they are raised with the
trolley jack. Never use the trolley jack at an
angle.
•
Position the trolley jack only where specified
by the vehicle manufacturer.
•
Make sure that no one leans against a raised
vehicle or load.
•
It must be possible for the operator to
observe the lifting equipment and the load
during all movements.
•
The equipment markings must be checked
to ensure that the original condition is
maintained.
•
The lifting equipment is not allowed to be
modified in any way which could have a
negative impact on the lifting equipment's
compliance with this standard (EN 1494).
Anl_CC_TJ_2000_SPK9.indb 9 Anl_CC_TJ_2000_SPK9.indb 9
GB

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Drain screw
2. Piston rod mount
3. Carry-handle
4. Lifting arm
5. Support plate
6. Roller
7. Guide roller
8. Lifting rod (2-part)
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions

3. Proper use

The hydraulic car jacks comply with EN1494:
2000+A1: 2008. They are designed for lifting
loads, preferably cars, at an ambient temperature
of -20°C to +50°C.
The following are prohibited:
•
Operation under difficult conditions or
conditions that are subject to special rulings
(e.g. strong magnetic fields, explosive
atmospheres, mines, seagoing ships);
- 9 -
05.09.2018 08:07:01 05.09.2018 08:07:01