Troubleshooting - Hendi 264409 Gebrauchsanweisung

Cleaning and maintenance
Attention: Always remove the plug from the socket,
turn to OFF position and let it cool down completely
before cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
Parts
All accessories such as crumb tray
(4), grid with handle (3), etc.
External surfaces
Interior surfaces

Troubleshooting

If the appliance does not function properly, please check the below table for the solution. If you are still unable
to solve the problem, please contact the supplier/service provider.
Problem
The appliance does not heat up
In case of any doubt, always contact your supplier!
Technical specification
Item no.: 264409
Operating voltage & frequency: 230V~ 50Hz
Rated power: 3645W
Protection class: Class I
Technical specifications are subject to change without prior notification.
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use
abrasive materials.
• Do not clean the appliance with steam cleaner
or water jet.
How to clean
- Soak in warm, soapy water or about
10 to 20 minutes.
- Rinse under running water thor-
oughly.
- Wipe with a soft clean cloth and a
little neutral detergent. Make sure
no water or moisture enter inside
the appliance.
- Remove any food residues or wood
chips residues
- Wipe with a soft clean cloth and a
little neutral detergent. Make sure
no water or moisture enter inside
the appliance.
Possible cause
Power plug is not connected properly
with the electrical power outlet.
Heating control knob (7) is not set.
Heating control knob (7) is defective.
Infrared heating element (2) is
defective.
Waterproof protection class: IPX3
Timer setting range: Up to 15 minutes
Dimension: 689x397x(H)318 mm
Remark
Dry all parts well at last.
Solution
Make sure the power plug is connec-
ted properly with the electrical power
outlet.
Set the heating control knob (7) to
the desired setting.
Contact the supplier.
Contact the supplier.
EN
7