GB
Manual reading
Caution
Manual reading is time consuming and only one
value at a time can be read. The parameter does
not have to be included in the LOG.SET file.
Retrieve a value for the Modbus client by using the "Read
holding registers" command with the desired parameter
address. Use NIBE Applications to see which parameter
address a value has. See section The Modbus command
on page 15 for more information.
Enter the values
Caution
Only one value can be entered at a time. The
parameter does not have to be included in the
LOG.SET file.
By using the "Write multiple registers" command with
the desired parameter address, a value can be updated,
if the heat pump permits it. See section The Modbus
command on page 15 for more information.
14