Before First Use - AEG RMB46211NX Benutzerinformation

46 www.aeg.com

BEFORE FIRST USE

INSTALLING WATER LINE
1. For models with Automatic Ice
Maker
– The water pressure should be
2.0~12.5 kgf/cm2 or more to run
the Automatic Ice Maker.
– Check your tap water pressure.
If a cup of 180 cc is full within 10
seconds, the pressure is appropri-
ate.
– If the water pressure is not high
enough to run the Automatic Ice
Maker, call the local plumber to
get an additional water pressure
pump.
2. When installing the water tubes,
ensure they are not close to any hot
surfaces.
3. The water filter only "filters" water. It
does not eliminate any bacteria or
microbes.
4. The filter life depends on the
amount of use. We recommend
you replace the filter at least once
every 6 months. When attaching the
filter, place it for an easy access (to
remove and replace) .
Note: After 6 months of first
power input, icon is flickering. To
eliminate the icon flickering, press
the light button for 3 seconds
after exchanging the water filter.
5. After installing refrigerator and water
line system, select WATER on your
control panel and press it for 2–3
minutes to supply water into the
water tank and dispense water.