Throttle Cable; Carburetor - GAS GAS enducross EC 2008 Betriebsanleitung

- Inspect the filter for damage such as tears, hardening, or shrinkage.
If damaged, replace it or it will allow dirt into the carburetor.
- Apply grease to all connections and screws in the air cleaner and
intake ports.
- Install the air filter in the motorcycle and make sure it is correctly
secured.
THROTLE CABLE
- Check that the throttle grip turns smoothly.
- Check that the throttle grip has 2-3 mm of free play.
- If the free play is incorrect, loosen the locknut on the upper end
of the throttle cable, and turn the adjuster to obtain the correct
amount of free play.
- Tighten the locknut again.
- Install the filter in the
cage and pack the
filter lip with grease
(A), to ensure good
sealing and prevent
dirt entrance.
(A). Adjuster.
(B). Locknut.
(C). Throttle grip.
25
- -
- If the free play cannot be set by adjusting the cable, remove the
cable protector in the throttle body. Make the necessary free play
adjustments with the tensor at the end of the cable, tighten the
locknut, and reinstall the protector.

CARBURETOR

Idle speed adjustment
Is carried out using the air screw (A) and idle screw (B).
- First turn in the air screw until it is loose, then tighten it 1 1/2 turns.
- After thoroughly warming up the engine, turn the idle adjusting
screw to obtain the desired idle speed. If there are no idle
preferences, turn the screw until the engine stops.
- Tighten lightly the idle screw..
- Open and close the throttle a few times to make sure the idle
speed does not change. Readjust if necessary.
- With the engine idling, turn the handlebar to each side. If handlebar
movement changes the idle speed, the throttle cable may be
improperly adjusted or routed incorrectly, or it may be damaged.
Be sure to correct any of these conditions before riding.
(A). Air screw.
(B). Idle screw.