Stopping The Motorcycle; Riding During The Break-In Period - GAS GAS enducross EC 2008 Betriebsanleitung

STOPPING THE MOTORCYCLE

For maximum deceleration, close the throttle (A) and apply both
front and rear brakes. Disengage the clutch as the motorcycle comes
to a stop. Independent use of the front or rear brake may be
advantageous under certain conditions.
Downshift progressively as speed is reduced to ensure good engine
response when you want to accelerate.

RIDING DURING THE BREAK-IN PERIOD

A break-in period is necessary to ensure a smooth operation and
obtain an optimum engine and the transmission responses. During
the first hour or 20 km of operation, run the engine at low and
moderate speeds and revolutions per minute (RPM).
NOTE
The slow riding necessary during the break-in period may cause
carbon deposits to build up on the spark plug and foul it. If
inspection of the spark plug shows this to be the case, replace
the standard spark plug with another of a higher heat range.
Perform the break-in period following these steps:
1. Start the engine and let it run at idle until the engine is warm.
2. Stop and let the engine cool completely.
3. Start the engine and ride for 10 minutes at moderate speed -
NEVER ACCELERATE HARD.
4. Stop and let the engine cool completely. Be sure to check and
adjust chain slack and spoke tightness and cxarry out a general
inspection.
5. Start the engine and ride for 20 minutes at moderate speed. -
NEVER ACCELERATE HARD.
6. Stop and let the engine cool completely. Check and adjust as
needed (Refer to the table of adjustments).
7. Install the parts removed.
8. Fill the radiator with the recommended coolant. Before starting
the motorcycle, bleed the air from the cooling system.
9. Start the engine and ride for 30 minutes at moderate speed.
10. Stop and let the engine cool completely. Check and adjust.
11. After the break-in procedure has been properly carried out, the
motorcycle is ready for regular operation.
However, avoid accelerating recklessly that can lead to engine failure.
Be careful to use the necessary skills and techniques while operating
the motorcycle.
After the break-in period, install a new set of standard spark
plugs.
- 16 -
CAUTION
NOTE