GAS GAS enducross EC 2008 Betriebsanleitung Seite 111

Spring adjustment
- Remove the seat and side covers.
- Loosen the air cleaner duct clamp screw.
- Remove the muffler.
- Remove the subframe with the air cleaner box.
(A). High and low
compression
adjustment.
(A)
37
-
Suspension spring
The standard spring is 5.2 (250 cc, 300 cc) - 5.0 (125 cc, 200 cc) -
5.6 (MC). The spring length preloaded with the shock absorber at
.
rest is 258 mm
(A)
- Tighten the locknut securely.
- After adjustment, move the spring up and down to make sure that
the spring is fully seated.
- Install the parts removed.
Rear shock absorber spring replacement
Harder and softer springs are available. If the standard spring is not
adequate for your purpose, select a proper one according to the
rider´s weight and the road conditions.
- Using the harder spring:The rebound is quicker.
- Using the softer spring:The rebound is slower.
Refer to the suspension adjustments on page 47.
-
(C)
(B)
(A). Nut.
(B). Spring.
(C). Locknut.
NOTE