Memory Function; Storage And Cleaning - Braun VitalScan 3 Gebrauchsanweisung

Memory function

Your blood pressure monitor can store the readings of 90 measurements (BP 1700
model: 60 measurements). Storing is done automatically after each completed
measurement. The memory is nonvolatile. This means that you will not lose stored
data when changing batteries. The memory cannot be cleared. Once the memory
is full, the oldest values will be overwritten.
The BP 1750 model features also an average function to display the average
reading of the last three measurements.
Recalling stored and average readings
• To recall stored and average readings, first turn the
device off.
• Then press the memory button («memo») (B).
BP 1750: The average of the last three readings will be
displayed. The lower display line shows «A-3», indicating
that the average value is displayed.
BP 1700: The last reading will be displayed. The lower
display line successively shows date, time and pulse of
the respective measurement.
• Repeatedly pressing the memory button will call up
one by one all stored readings.
• Continuously pressing the memory button will scroll
through all stored readings.
• To exit the memory mode, turn the device off by
pressing the red I/O button.
6
Setting time and date
• Push the time/date button (C). The lower display line shows «Time» and a
flashing digit in the hour position. To adjust the hours, repeatedly push the
«memo» button.
• Push button (C) again: The minutes digits will flash. Again, repeatedly push the
«memo» button to adjust the minutes.
• Push button (C) again to adjust the date: The lower display line shows «Date»
and flashing digits in the month position. Adjust the month by repeatedly
pushing the «memo» button.
• Push button (C) again: The day digits will flash. Again, repeatedly push the
«memo» button to adjust the day.
• To exit the time and date setting mode, push button (C).
• Otherwise the device automatically turns off after 2 minutes and activates the
settings made so far.

Storage and cleaning

Clean the product with a soft, slightly damp cloth. Stains on the cuff (G) can be
carefully removed with a damp cloth. Do not wash or dry clean the cuff. Do not
memo store the product in a place exposed to direct sunlight or high humidity.
Calibration
memo
This product has been calibrated at the time of manufacture. If used according to
the use instructions, periodic recalibration is not required. If at any time, you
question the measuring accuracy, please contact an authorized Service Centre
memo
(see package insert for a local Service Centre).
Time
7