Turning Off; Memory Mode - Braun VitalScan 5 Gebrauchsanweisung

5. If your wrist position is accurate the the green arm icon on
the device will appear with a black outline and the device will
sound "BEEP BEEP BEEP BEEP". Directly following the the four
beeps the device will automatically inflate and begin taking
the user's reading. When the measurement is complete the
reading is displayed on the LCD.
Top: systolic value
Middle: diastolic value
Bottom: pulse
If the measuring position is incorrect, the measurement can't
BEEP BEEP BEEP BEEP
start, so there is no possibility to obtain a wrong or inaccurate
measurement.
The device will beep rapidly if the positioning system is incor-
rect. You have to move your arm up or down according to the
arrow indication on the LCD screen.
If your wrist position is at the correct level with your heart, the
BEEP BEEP BEEP BEEP
LCD will display and the measurement will start.
Measuring arm: if your wrist position is lower than your
heart, the LCD will display as shown and will beep as
"BEEP BEEP BEEP BEEP".
If your wrist position is higher than your heart, the LCD will
display as shown and will beep as " BEEP BEEP BEEP BEEP".
If the positioning system has been deactivated, you will have
no indication before processing the measurement.
Please note:
• In case of system errors or handling mistakes, the display
will show an error code, instead of giving you inaccurate
results (for details, please see section «What to do if...»).
8

Turning off

Press the on/off button to turn the product off, otherwise the
product will turn off automatically after 2 minutes.

Memory mode

Your blood pressure monitor can store the readings of 80 (2x40)
measurements. Storing is done automatically after each com-
pleted measurement. The memory is non-volatile. This means
that you will not lose stored data when changing batteries.
Once the memory is full, the oldest values will be overwritten.
How to review the memory
• Make sure the product is in power off mode.
• Press the memory/average function button. The LCD will
display the past 7 days average of blood pressure first.
• Press the memory/average function button again and the
latest reading will display.
• Press it again and the next reading will display.
Average function: 7 day average
• Press the memory/average function button once, and the
"7 day average" result will show on LCD.
• Make sure the date / time is correct when taking a measure-
ment, so you will get the correct 7 day average result.
• If there is no data in memory within past 7 days, "
" will show on LCD.
How to delete the memory data
• Make sure the product is in power off mode.
• Press the memory/average function button for at least 10
seconds.
• LCD will display "del no" as shown.
• Press the memory/average function button again. LCD will
display "del yes".
• If you are sure all the data of corresponding user can be
deleted, press "power" button, all the corresponding user's
data will be deleted and the device will shut down.
Note: if you have set "delete yes", but do not press a button
for 2 minutes, the product will shut off automatically, but the
9