Silvercrest SQWP8000 1A1 Bedienungs- Und Sicherheitshinweise Seite 18

The device is not connected. Check that it is connected. Briefly
press the ON / OFF button 5 to begin the charging process.
The current consumption of the connected device might be too
low.
Check with your connected device manual and see if your
connected device current consumption comply with this product.
The minimal output current of the power bank is approx. 50 mA.
The power bank does not react when the button
8
is pressed or when a device is connected, even
though the battery is charged.
The power consumption of the connected devices is too high.
Therefore, the internal overcurrent protection device was
activated.
Reduce the number of devices connected and press the ON /
OFF button .
5
Wireless charging did not start
Device to be charged is not placed at the Centre of the Qi mark
location.
Make sure your device to be charged is at the correct position
at the centre of the Qi charging surface of the power bank
7
8 .
Make sure that there are no other objects on the charging pad.
Remove your device's protective case as it may be blocking the
wireless signal.
Wireless charging speed slow
Device to be charged is too far away from the centre of the Qi
charging surface 7 .
Make sure your device to be charged is at the correct position at
the centre of the Qi charging surface 7 of the power bank 8 .
GB 18