Initial Use; Operation - Beurer MP 59 Gebrauchsanweisung

4. Initial use

• Remove the packaging.
• Check the device, mains adapter and cable for damage.
• Connect the device to the mains. When doing so, the device must be switched off.
• Ensure that the cable does not pose a trip hazard.
• Charge the device for approximately 1.5 hours before the first use. If the battery level
indicator flashes slowly this means that the battery is charging. Once the display is
permanently illuminated, the device is fully charged. You can now begin using the device
on battery power.
• If the battery level indicator flashes rapidly during battery operation, the battery is empty.
Charge the device by placing it on the charger, ensuring that the contact points on the
bottom of the device are connected. Connect the charger to the mains cable. Insert the
mains adapter into a suitable socket.
• One charge is sufficient for approx. 1 hour of cordless operation.
IMPORTANT
• When switched on, the device should not come into contact with other areas of
skin (e.g. eyelashes, head hair etc.), or with clothes or cords, to avoid injury as well
as blockages or damage to the device.
• Do not use the device on irritated skin, varicose veins, rashes, spots, (hairy)
birthmarks or wounds without consulting a doctor beforehand. The same applies
to patients with weakened immune systems, diabetes, haemophilia and immune
insufficiency.
Note
• The portable pedicure device can be used on dry or wet skin.
• When used on dry skin, the skin must be completely dry and free from grease.
• Do not use any cream before removing calluses.
• Do not remove too much of a callus as it may grow back stronger.

5. Operation

• Make sure that the abrasive roller is correctly inserted into the device.
• Press the on/off switch for 1 second to switch on the device. The battery level indicator
flashes 3 times and the device starts in the slower speed setting.
• To switch between the two speed settings, briefly press the 1/2 button.
• You can now remove severely callused skin using the coarse abrasive roller.
• If you wish to remove slightly callused areas or smooth your skin, use the fine callus
attachment.
• Do not use the device for longer than 3 – 4 seconds on one area of the skin.
• The device switches off automatically if the abrasive roller is prevented from moving for
approx. 3 seconds due to too much pressure being applied during use.
• Do not use the portable pedicure device on irritated, sore or broken skin.
• Move the device slowly and evenly over the callus. Make sure you hold the device
vertically at a 90° angle to the callus. To achieve optimum results, it may help to move the
device over the callus in different directions.
15