Device Description; Initial Use; Carrying Out A Skin Test; Usage - Beurer Pureo Derma Peel Gebrauchsanweisung

• Never reach for a device that has been submerged in water. Disconnect the mains adapter imme-
diately.
• Do not drop the device or subject it to any impacts.
• Do not clamp or pinch the mains cable.
• Ensure that the mains cable and mains adapter do not come into contact with water, steam or other
liquids.

5. DEVICE DESCRIPTION

The associated drawings are shown on page 3.
Mirror
1
Large attachment with fine sapphire coating,
3
suitable for sensitive skin
Storage box with single-use filters
5
Intensity level display (level 1-5)
7
Open button
9
Tube
11

6. INITIAL USE

Before you start using the device, make sure that your face is clean, dry and free of any traces
of products such as powder, cream or make-up.

6.1 Carrying out a skin test

Carry out a skin test 24 hours before using the device. Test the device at the lowest intensity level on
small, inconspicuous areas of your neck. If after 24 hours the tested area is red or painful, do not use
the device.
WARNING
• Do not use the device more than once a week.
• Immediately after use, the treated skin may be slightly reddened and in very rare cases there may
be small spots of bleeding under the skin.
• For one day before and one day after use, avoid activities that cause you to perspire, such as sau-
nas, tanning beds and sun exposure.
The device can also be used twice a week for non-sensitive problem skin (with a break of at
least 48 hours between use).

7. USAGE

7.1 Using the device

1. Connect the mains adapter to the device and plug the adapter into the socket.
2. Press the Open button to open the device.
3. Insert a single-use filter into the end of the tube.
4. Connect the end of the tube to the hand-held device.
Precision attachment with fine sapphire coat-
2
ing, suitable for precise treatment of small
areas (e.g. in nose area)
Coarse attachment with coarse sapphire
4
coating, suitable for intensive treatment of
problem areas
Hand-held device
6
-/+ buttons for setting the intensity level
8
ON/OFF button
10
A1
A2
A3
15