Skoda Octavia II Bedienungsanleitung Seite 29

29
- By means of four screws M10 x 35 (B), fasten the beams to the chassis of the
vehicle -detail- and tighten the screws on both sides (alternately) by the torque
of 70 Nm.
In next disassembly and assembly of the towing coupling, the clamp screws
have to be replaced with new ones.
- 6, 7 -
- Check the fitting of the towing arm (C) in the clamping bush (see the Operation
Manual of the towing coupling ).
- Fit the cover (D) upon the clamping bush of the towing coupling.
Next, proceed to the mounting of the electric installation of the towing
coupling upon the vehicle (see the instructions for mounting the electric
installation of the towing coupling).
Having finished the mounting of the electric installation, mount all the dismounted
parts back to their places and tighten the respective connections at the prescribed
torque moments.
After the mounting has been finished, attach the self-adhesive label (E) above the
cutting in the rear bumper (before attaching it, clean and degrease the place with a
suitable cleaning agent).