Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Now crossfading between the two channels selected is possible:
• crossfader moved to the left: fade-in of side A and fade-out of side B
• crossfader moved to the right: fade-in of side B and fade-out of side A
• For hearing the signals of the two channels at the same level, set the crossfader to mid-position.
4
For mixing the signals of the other input channels to the music program, advance the corresponding
faders accordingly.
5
If crossfading is not required, the connected audio sources can be switched directly to the master signal:
Set the corresponding assignment selectors to position "M" and adjust the desired volume ratio of the
audio sources with the channel faders.
6.4 Announcements via the DJ microphone
1
To switch on the DJ microphone at the jack DJ MIC press the button ON AIR (control LED lights red).
2
Adjust the volume of the microphone announcement with the control LEVEL.
3
Adjust the desired sound with the 3-band equalizer. By adjusting the tone controls, the high frequencies
(control TREBLE), the middle frequencies (control MIDDLE) and the low frequencies (control BASS) can
be boosted or attenuated (± 12 dB).
4
To improve the audibility of an announcement during the current music program, press the button
TALKOVER (control LED lights blue) to activate the talkover function. Then during a microphone
announcement, the levels of channels 1-5 are automatically attenuated by 15 dB.
5
To switch off the DJ microphone press the button ON AIR again (control LED off).
6.5 Prefader listening to the channels
The cue function allows monitoring each of the channels 1-5 via headphones even if the corresponding
channel is faded out. Thus, it is possible, e. g. to time the moment for fading in an audio source. Alternatively
it is possible to monitor the current music program ahead of the master fader or the output controls MASTER
2, MASTER 3 and BOOTH LEVEL.
1
For prefader listening to a channel, press the corresponding switch CUE (control indicator lights) and set
the fader CUE MIXING to the left position "CUE". To monitor the current music program ahead of the
master fader and the output controls MASTER 2, MASTER 3 and BOOTH LEVEL, set the fader CUE
MIXING to the right position "MASTER".
2
Select the monitoring mode with the selector switch CUE MODE:
• SPLIT (button pressed, red LED lights): The prefader level (mono) is on one side and the output signal
(mono) is on the other side of the headphones.
• MIX (button released, blue LED lights): A mixed signal of prefader level and master signal is on both
sides of the headphones.
3
Adjust the desired headphones volume with the control CUE LEVEL.
6.6 Using the fader start function
When two CD players with contact control are connected to the MX-540, they can be remote controlled
with the crossfader (fader start function).
1
Use the crossfader assignment switches to assign the two input channels to be remote controlled to a
crossfader side:
• position A: the channel is switched to side A
• position B: the channel is switched to side B
2
Press the buttons FADER START to activate the fader start function for the crossfader (control LEDs
light blue).
3
By advancing the crossfader the corresponding CD player is set to play mode. By closing the crossfader
the CD player returns to the last set cue point and changes into pause mode.
4
To switch off the fader start function press the buttons FADER START again (control LEDs off).
25/27
00041735.DOC, Version 2.0
Werbung
Inhaltsverzeichnis
