Omnitronic MX-540 Bedienungsanleitung Seite 21

30 AC connection
Plug in the mains cable of the supplied power unit here
and fix it with the union nut.
31 Power on/off
Press this button to turn the unit on and off.
32 Master outputs
• Stereo outputs of the three master channels for
connecting amplifiers or other units with line level
inputs.
outputs 1 (optionally XLR, bal. or RCA) for master
channel 1
outputs 2 (optionally XLR, bal. or RCA) for master
channel 2
outputs MASTER 3 (optionally 6.3 mm jack, bal. or
RCA) for master channel 3
• The outputs can be switched to mono by pressing the
selector switch STEREO/MONO at the front panel.
33
Output BOOTH
Stereo output (RCA) for connecting a further amplifier,
e.g. for the monitoring system or PA application in a
secondary room.
34 Output REC(ORD)
Stereo output (RCA) for connecting a recording unit. The
recording level is independent of the position of the
master fader and the output controls MASTER 2,
MASTER 3 and BOOTH LEVEL.
35 Inputs LINE 1-12
Stereo inputs (RCA) for channels 1-5 for connecting units
with line level outputs (e.g. CD players).
36 Inputs PH/LINE
• Stereo inputs (RCA) for the channels 1-3 for connecting
turntables with magnetic system.
• With the corresponding input selector switches the
inputs can be switched to line level.
37 GND (ground terminals)
Ground clamping screws for turntables connected to the
channels 1-3.
38 Microphone input DJ MIC
• Rear microphone input (6.3 mm jack) for the DJ
microphone channel. When connecting a microphone,
the LED REAR MIC IN on the front panel lights up.
• With the corresponding input selector switch the DJ
microphone input can be switched to line input for mono
units with line level output.
39 Input selector switch
Switches the microphone input DJ MIC to line input.
40
Input selector switches
Switches the phono inputs to line inputs.
41 Input selector switches
Switches the channels 3-5 between microphone input
and line input.
42 Microphone inputs
6.3 mm jacks for the channels 3-5 for connecting
microphones.
43 Level selector switches
Switches the level at the master outputs 1 and 2 between
0.75 V and 1.5 V.
44
Connectors X-FADER START
3.5 mm mini jacks for remote control (fader start) of CD
players with contact control. Caution! Never apply mains
voltage to these jacks.
21/27 00041735.DOC, Version 2.0