Using A Portable Tuner Mount Adapter - Sony WRR-855S Bedienungsanleitung

tuner unit is equipped. The WRR-855S can
be attached to the Camcorder using that
slot.
For details on how to attach the WRR-855S to the
Camcorder, refer to the Operation Manual supplied
with the Camcorder.
Using a Portable Tuner
Mount Adapter
This section shows you how to mount the
WRR-855S to the BTA-801 Portable Tuner
Mount Adapter (not supplied) for example.
By properly mounting the WRR-855S to
the BTA-801 and attaching the two
supplied antennas, a weatherproof structure
is obtained.
To mount the tuner unit to the
portable tuner mount adapter
Note
Before mounting, be sure to clean the
abutting surfaces of the WRR-855S and the
BTA-801.
1
After observing the direction, insert
the WRR-855S in the BTA-801.
2
Push the WRR-855S down until the
accessory connector clicks into place.
3
Run in the four mounting screws little
by little in turn to gradually secure the
tuner unit and the adapter together,
then tighten them.
10 Preparations
WRR-855S
To connect the power cable
Connect the DC 12 V IN connector of the
BTA-801 to the DC OUT connector of the
Camcorder using the DC power cable
supplied with the BTA-801.
BTA-801 (bottom)
To remove the power cable
Pull the metal part of the connector in the
direction of the arrows and remove.
BTA-801
Match the
connector pins
with the connector
inside and insert.
DC power cable
(supplied with the
BTA-801)