Initial Startup; Permissible Mains Grid Impedance; Operation - Kärcher IVS 100/40 60 Hz Bedienungsanleitung

Indicator lamps
Green
 Blink codes for teaching the remote
control (IVS 100/55 and IVS 100/75).
 Lights up when the suction turbine is
running.

Initial startup

1. Bring the device into the working posi-
tion and secure with the parking brake if
necessary.
2. Insert the suction hose into the suction
hose connection.
3. Plug the desired accessory onto the suc-
tion hose.
4. Ensure that vacuum cleaner waste con-
tainer is inserted correctly.
Permissible mains grid
impedance
DANGER
Warning
The maximum permissible mains grid im-
pedance at the electrical connection point
(see technical data) must not be exceeded.
Contact your electricity supplier in the case
of any uncertainties regarding the mains
grid impedance at your electrical connec-
tion point.

Operation

Switching on the IVS 100/40 device
1. Connect the mains plug.
2. Switch on the device at the main switch.
Switching on the IVS 100/55 and IVS
100/75 devices
1. Connect the mains plug.
2. Switch on the device at the main switch.
3. Press the "Switch-on device" button.
Vacuuming process
1. Perform vacuuming.
2. Regularly check the filling level in the dirt
receptacle, since the device does not
switch off automatically.
3. Empty the vacuum cleaner waste con-
tainer as necessary.
4. Clean or replace the filter as necessary.
Cleaning the filter
A pressure gauge showing the vacuum in-
side the device is mounted on the front of
the device.
IVS 100/40 60 Hz
1 Switch off the device at the"ON/IFF
switch".
2 Move the filter cleaning lever back and
forth several times.
IVS 100/55 and IVS 100/75 60 Hz
1 Press "Switch off device" button.
2 Move the filter cleaning lever back and
forth several times.
If this cleaning does not result in an im-
provement, the filter can be removed and
washed or replaced (see section"Changing
the filter").
Use dust collection bag
A dust collection bag can be inserted in the
vacuum cleaner waste container to allow
dust-free emptying of the device.
Note
The dust collection bag must not be used
for wet vacuum cleaning.
1. Insert the dust collection bag in the vac-
uum cleaner waste container and care-
fully press it against the wall of the
container.
2. Pull the edge of the dust collection bag
over the edge of the vacuum cleaner
waste container.
3. Insert the vacuum cleaner waste con-
tainer into the device.
4. On completion of vacuuming, close the
dust collection bag and remove it from
the vacuum cleaner waste container.
5. Dispose of the dust collection bag ac-
cording to the applicable waste disposal
regulations.
Dry vacuuming
WARNING
Risk of damage
When changing from wet vacuuming to dry
vacuuming, please note that vacuuming
dry substances with a wet filter can damage
the filter and make it unusable.
English 11