Operation - Husqvarna CG 200 Bedienungsanweisung

3. Fit the drum and slid it on its shaft.
To connect the dust extractor
Always use a vacuum cleaner to minimize dust. Make
sure that the filters in the vacuum cleaner are intact and
clean. Pay attention to dust during operation.
Introduction
WARNING: Please read the operator's
manual carefully and make sure you
understand the instructions before using the
product.
WARNING: Wear personal protective
equipment. See
equipment on page 7 for instructions.
WARNING: Make sure no unauthorised
persons are in the working area, otherwise
there is a risk of serious personal injury.
WARNING: Check that the product is
assembled correctly and do not show any
signs of damage.
CAUTION: The equipment fulfills the
requirements in EN61000-3-11 and is
subject for conditional connection to the
mains. It may be connected in consultation
with the supply authority. The equipment will
only be connected to the mains supply with
impedance lower than 0,26 ohm. The
system impedance at the interface point
may be obtained from the supply authority.
If the mains supply has higher system
impedance, short voltage dips may appear
when the equipment is started. This may
influence the operation of other products,
e.g flickering lights.
8

Operation

Personal protective
1. Connect the dust extractor (1) to the product.
To start up
CAUTION: The operator position is behind
the product keeping both hands on the
handles. Maintain a safe distance to the
rotating tool. Make sure that no pipes or
electrical cables are routed in the working
area or in the material to be cut. Do not
leave the product unattended while the
engine is running.
Note: When the product is engaged it will move forward
uncontrolled due to the activated drum.
1. To start the product, grasp the operator presence
control handle on the steering shaft.
130 - 003 - 18.08.2017