Programming The Appliance - Silvercrest SVSV 550 C3 Bedienungsanleitung

Programming the appliance

♦ Press the
lamp of the
♦ Press one of the temperature buttons
as the preset temperature. This is not the current temperature. Additionally
:
♦ Set the desired water temperature at which the food is to be cooked using
the temperature selection buttons
is shown on the display
♦ Set the desired time period for which the food is to be cooked using the
time selection buttons
minute between 1 minute and 24 hours. You can set the time in fast mode
by pressing the time selector keys
♦ Press the
temperature is shown on the display
NOTE
► The
to the set temperature.
► As soon as the set temperature is reached, you will hear a beep.
Additionally the symbol appears on the display
down a minute at a time on the display
♦ As soon as the programmed time has elapsed, you will hear three beeps
and
short period of time.
♦ Press the
♦ Remove the lid
the condensation on the underside of the lid
.
♦ Remove the food using a suitable kitchen implement (e.g. kitchen or barbecue
tongs) from the water container
♦ Remove the plug from the mains power socket.
♦ Cut open the vacuum bag and remove the food. Depending on the food,
it can served immediately or must be prepared further (e.g. briefly fried).
SVSV 550 C3
button for 2 seconds to switch the appliance on. The control
button lights up red and
(one hour) appears on the display
. You can set values between
button
symbol on the display
appears on the display
button for approx. 2 seconds to switch off the appliance.
. When doing so, try to ensure that as much as possible of
appears on the display
. °C is shown on the display
.
. You can set the time accurate to the
to start the programme. The current water
.
shows that the water is now being heated
.
. The display
runs into the water container
.
. The selected temperature
°C and °C.
for a longer period.
and the time counts
will go out after a
25
GB│IE
│
.
■