BEBE CONFORT AxissFix Gebrauchsanleitung Seite 56

EN
WARNING:
Never combine two ISOFIX anchorage and car seat
belt systems to install your child car seat.
ATTENTION:
In ISOFIX use the fitting clips for lower anchorage
to the vehicle is not sufficient. It is essential to fix
the "TOP TETHER" to the upper anchorage point
recommended by the car manufacturer.
Fitting the AxissFix seat with additional tethers
using the vehicle's ISOFIX additional anchorage
points.
The ISOFIX anchors have been developed to
obtain a safe and easy fixation of the child safety
systems inside the car. Not all cars are equipped
with these anchors although they are standard on
more recent models. Consult the attached list of
cars for which the car seat can be installed
correctly (you can also consult additional updates
of this list on the website www.bebeconfort.com)
• In rear-facing position (61-87 cm), this product
must not be installed to places equipped with a
frontal air bag. You might be able to deactivate
it (see your car manual). In this case, if you can
deactivate the air bag, you can use the car seat
on the front seat.
• In forward facing position (76-105 cm), the seat
must be placed on the car rear seat or
exceptionally on the front seat in accordance
with the legislation in force in the country of
use (In France: in accordance with the
conditions stipulated in decree n° 91-1321 du
27-12-1991). If you use the AxissFix on the front
seat, it should be possible to deactivate the
58
( )
airbag of the seat in question or move the
passenger seat back to a maximum (Please
consult your car manual).
• When installing the seat in the rear-facing
position, the belt of the TOP TETHER can turn
one quarter turn according to the position of
the anchorage point. This does not impair the
proper operation of the product.
• When installing the car seat, it is necessary
to remove the headrest in order to put the
TOP TETHER through correctly.
• Warning: when installing the car seat, spaces
between the base of the car seat and the
vehicle seat are possible depending on the
position of the anchorage points within the
vehicle.
• It is essential that the car seat be replaced after
an accident.
• The user must always check that any luggage
and other objects likely to cause injury to the
occupant of the car seat in the case of impact
are properly secured.
• The rigid parts and the plastic sections of a child
restraint device should be positioned and
installed in such a way that they cannot, when
the vehicle is being used under normal
conditions, become trapped under a moving
seat or in the vehicle door.
• Never modify the construction or the materials
of the car seat and the seat belt without
consulting the manufacturer.
• Do not use the child restraint device without
the cover. Do not replace the seat cover with a
cover other than that recommended by the
manufacturer, because it will have a direct