SUNTEC KLIMATRONIC SUMMIT plus Bedienungsanleitung Seite 20

Istallation
The unit should stand 50 cm away from other objects because they can strongly influence performance of the
device ( The unit should stand 50 cm away from other objects because they can strongly influence
of
performance the device (Fig. 1).
Warning: Before using this unit, you should Iet it stand straight for at least 24 hours.
The unit can be easily moved between rooms, but please note the following:
Assembly of the heat exhausts outer connector (Figure 1A), heat exhaust hose short connector (Figure
2A), and the heat exhausts outer connector and heat exhaust hose short connector (Figure 1, Figure 2).

Dismantle the two pieces of the heat exhaust hose outer connector; these two pieces are equal in
form.

Hold each piece with one hand, put the joint of one piece toward the other one's groove, and press
them to make them snap tightly (Figure 1A).

Take out the heat exhaust hose and the round connector, pull the few turns of the hose end apart,
and screw it counter clockwise into the whorl side of the round connector to form heat exhaust
hose assembly A (Figure 2A).

Pull the few turns at the other end of the heat exhaust hose apart, screw the round end of the heat
exhaust hose outer connector counter clockwise into the heat exhaust hose to form the heat
exhaust hose assembly (Figure 1).

Figure 2 shows the final assembled exhaust hose.
Note：When press the two pieces of the outer connector, exert the strength from small to big, so
as not to cause any damage to it. The joint must be pressed into position. The heat exhaust hose
Fig. 1
Fig. 1A
Fig. 1
Fig. 2A
Fig. 2
20