Startup / Operation - BOMANN GB 388 Bedienungsanleitung

Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION CAUTION: : : :
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening Reverse the door opening
Reverse the door opening Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE
NOTE NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
electric
electric electric
screw wrench, Phillips screw-
• Remove the blind cap (1) and the hinge cover (2).
• Dismount the upper door hinge (4) by loosening
the screws (3). Opfen the appliance door a little
and lift it out of the lower door hinge.
• Displace the blind plug (9) of the appliance door
accordingly. Place the appliance door safely
aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet (7+8).
• Dismount the lower door hinge (5) by loosening
the screws (6).
• Displace and attach the door hinge (5) at the op-
posite appliance side. Turn in the feet (7+8)
accordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Displace and attach the upper door hinge (4) at
the opposite appliance side.
• Insert in the blind cap (1) at the opposite hole and
put on the hinge cover (2) again, which you have
removed at the beginning.
• Check if the door is aligned vertically and horizon-
tally optimally so that the smooth opening and
closing of the door is guaranteed.

Startup / Operation

Startup / Operation
Startup / Operation Startup / Operation
Prior to first use Prior to first use
Prior to first use Prior to first use
CAUTION: CAUTION: CAUTION: CAUTION:
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
18