SCHUBERTH F220 Gebrauchsanleitung Seite 20

USE
The SCHUBERTH F220 firefighter helmet is available in one helmet shell size
and approved for a head size range of 53 cm to 62 cm.
Adjusting the head width
By turning the rotary knob clockwise or
counterclockwise you can make the head width
narrower or wider.
Adjusting the wearing height
The wearing net (wearing height!)
is adjusted by moving the two rear net holders.
E
After loosening the net holder (D) from the guide
straps (E), it can be adjusted to the required
wearing height and fixed in place by snapping
into the guide straps' holes (E). Please make sure
that the studs are firmly pressed in.
D
Adjusting the chin and neck strap
The chin strap's quick release ensures easy open-
ing and fastening of the chin strap. Grasp the helmet with both hands on the
chin-neck strap and pull it over your head from the forehead.
Fasten the chin strap with the quick release fastener. The neck strap must be
tight under the ears and at the back of the head. A double buckle is provided
for adjusting the length of the neck strap. The chinstrap must be snug under
the chin. If necessary, the chin strap's length can be adjusted and fixed to the
Velcro fastener.
WARNING: The SCHUBERTH F220 helmet complies with the
requirements of the DIN EN 443:2008 standard on the retention system if
the chin strap supplied by the manufacturer has been worn and adjusted in
accordance with these instructions.
20