Starting Operation; Machine Operation - Jet JTSS-1600 Gebrauchsanleitung

Attention:
‐Check first if the saw spindle runs freely and if all safety devices
are fitted before starting the machine.
‐ If the direction of rotation is not correct, the phase converter
inside the CCE Euro plug must be pushed in and turned 180°.
(Clockwise direction of the main spindle is correct).
For safety reasons this must only be done without the sawblade
installed!
5.5 Starting operation
You can start the machine with the green ON‐button.
The red OFF‐button stops the machine (H, Fig 20‐1).
The scoring sawblade is started and stopped simultaneously with
the main sawblade.
Note:
‐When the lower sawblade cover is open, it is impossible to start
up the machine.
‐In case of machine overload the motor overload cut‐off will react.
After appr.10 min of cooling the machine can be started again.
Emergency stop:
Press E‐stop button (O, Fig 20‐2) to shut down all machine
operations.
Note:
The E‐stop remains engaged until it is rotated clockwise for release
Fig 20‐1
Fig 20‐2
6. Machine operation
Correct working position:
In front of the machine standing out of the line of cutting (danger
zone) Fig 21.
Work piece handling:
Hands placed flat on the work piece outside the cutting area.
Feed the work piece towards the saw blade in the direction of the
saw line. Push the work piece steadily forward; complete the cut
as a single movement.
Support long and wide workpieces with helping roller stands.
The use of a power feeder is not considered.
Crosscut with crosscut fence (Fig 22‐1).
Trimming with back stop (Fig 22‐2).
Fig 21
Fig 22‐1
Fig 22‐2