Dust Connection; Mains Connection - Jet JTSS-1600 Gebrauchsanleitung

Place a T‐nut into the top slot of fence, thread the stud of hold‐
down on fence.
If needed, put the hold down arm onto the stud (E).
Reference to chapter 7.8
Mounting Mitre Fence
See chapter 7.9
Mounting Sawblade
See chapter 7.1
Mounting sawguard
The riving knife has slots for different blade sizes Fig 18
Min blade size Ø 250mm, max blade size Ø315mm
Reference to chapter 7.3
5.3 Dust connection
Install the 50mm dust hose onto the blade guard with hose clamp.
Fig 19.
Fig 17
Fig 18
Put the 50mm dust hose onto dust hose support, to keep free with
the working table.
Another end of 50mm dust hose clamps to the main dust port on
the bottom of rear panel.
Install 100mm dust hose to main dust port with hose clamp.
Before initial operation, the machine must be connected to a dust
extractor.
The suction should switch on automatically when the saw is
switched on.
A hose, a Y‐piece and a hose support are supplied with the
machine.
The flow rate on the suction port dia 100mm must be 20m/sec.
Flexible hoses must be of non‐flammable quality, and must be
connected to the machine ground system.
5.4 Mains connection
Mains connection and any extension cords and plugs used must
comply with the information on the machine licence plate.
The mains connection must have a 16A surge‐proof fuse.
Only use connection cables marked H07RN‐F, with wires 1,5mm
or more.
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only be
carried out by qualified electricians.
The machine is equipped with a 16Amp CCE Euro plug, mounted at
the back side of the frame.
Fig 19
2