Jet JTSS-1600 Gebrauchsanleitung Seite 9

Mounting rip fence rail:
Insert four M10x80 hex head bolts into rip fence base rail (Q, Fig
9).
Loosely attach two M10 hex nuts with washer in between for each
bolt.
Mount the rip fence base rail to the front of the saw table and
right table extension with M10 hex nuts.
First tighten nuts on two external bolts, aligning the rail parallel
with the table, and then tighten the other nuts.
Insert the scale carrier (I) and attach with nuts and washers.
Fig 8‐2
Fig 9
Mounting rip fence:
Mount the rip fence to the rip fence base rail (Fig 10).
Mounting the main blade elevation & angle handwheel:
Fitting the elevation handwheel(1, Fig 11) and angle handwheel (2)
onto the elevation and angle shaft.
Install the handwheel lock knobs (3 & 4).
Mounting the sliding table:
Lift the sliding table onto the machine and attach with T‐bolts and
nuts .
Fig 10
Fig 11
Fig 12‐1