Troubleshooting - Jet JTSS-1600 Gebrauchsanleitung

Make sure the belt is not over tensioned, because this could lead
to damage of the saw arbor and bearings.
Main drive belt changing:
Move the blade tilt to 0˚ (Blade 90˚ to table) on the control panel
and raise the blade as far as it will go.
Move the sliding panel all the way to the left and remove two
M6x12 pan head screws to expose the internal blade guard that
covers the blades and riving knife.
Remove the blade guard from the riving knife to expose the
mounting assembly.
Remove the main blade.
Remove M8 Allen screws and remove the inner chip house (Fig 37).
Note: for better access, tilt the saw blade.
Loosen the belt tension and remove the belt (Fig 38).
Replace new V‐belt, tension belt, close the left panel, and re‐
mount inner chip house, saw blade and blade guard.
Reattach the rear machine access door.
Scoring unit belt tensioning:
The scoring unit belt is self‐tensioning by spring load (Fig 39).
Fig 37
Fig 38
Scoring unit belt changing:
Move the blade tilt to 0˚ (Blade 90˚ to table) on the control panel
and lower the blade as far as it will go.
Remove the 4 Allen screws on the top and bottom of right panel,
and remove the left panel.
Push the tension pulley against the spring load.
Remove the old belt and replace new belt.
Re‐mount the right panel.
Motor Break:
The motor break works electro‐mechanically (break motor).
If breaking time should exceed 10 seconds, the motor break
assembly needs to be replaced. Contact your Jet service station
immediately.
9. Trouble shooting
Motor doesn't start
*No electricity
‐check mains and fuses.
*Defective switch, motor or cord
‐consult an electrician.
*Overload has reacted
‐Wait and start again.
*Lower sawblade cover still open
‐ Close cover correctly.
Machine vibrates excessively
*Stand on uneven floor
‐adjust levelling screws for even support.
*dust on saw flanges
‐clean saw arbor and flanges.
*defective sawblade
‐ replace sawblade immediately
*Bad V‐belts
‐replace V‐belts
Cut is not accurately square
*Stops not adjusted correctly
‐check with square and adjust stops.
Fig 39