Beurer ME 80 Gebrauchsanweisung Seite 50

Table 3
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic immunity
The ME80 is intended for use in the electromagnetic environment specified below. The customer or the user
of the ME80 should assure that it is used in such an environment.
IMMUNITY test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
interruptions and voltage
variations on power supply
input lines IEC 61000-4-11
Power frequency (50/60 Hz)
magnetic field IEC 61000-4-8 3 A/m, 50/60Hz
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
IEC 60601 Compliance
test level level
± 6 kV contact ± 6 kV contact
± 8 kV air ± 8 kV air
2 kV for power 2 kV for power
supply lines supply ports
1 kV for input/out- 1 kV for input/out-
put lines put and commu-
nication ports
<5 % U <5 % U
T
(>95 % dip in U ) (>95 % dip in U
T
for 0,5 cycle for 0,5 cycle
40 % U 40 % U
T
(60 % dip in U ) (60 % dip in U
T
for 5 cycles for 5 cycles
70 % U 70 % U
T
(30 % dip in U ) (30 % dip in U
T
for 25 cycles for 25 cycles
<5 % U <5 % U
T
(>95 % dip in U ) (>95 % dip in U
T
for 5 sec for 5 sec
3 A/m
50
Electromagnetic environment –
guidance
Floors should be wood, concrete
or ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30 %.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
T
) of a typical commercial or hospi-
T
tal environment. If the user of the
ME80 requires continued operation
during power mains interruptions,
T
) it is recommended that the ME80
T
be powered from an uninterruptible
power supply or a battery.
T
)
T
T
)
T
Power frequency magnetic fields
should be at levels characteristic of
a typical location in a typical com-
mercial or hospital environment.